Problem
I have installed SCO OpenServer 5.0.4 and configured my network. It is working properly; however, after installing Release Supplement 504C, I receive a warning message on bootup during the hardware display:
WARNING: <driver>: cannot install intr vecno=65535 Bad interrupt vector 65535
Another similar error message is the following:
idistributed: <driver> bad interrupt vector (65535)Network capabilities may no longer work.The addition of Release Supplement 504C adds some updated network
drivers. Some of these network drivers appear to not function
properly. Solution
This is not a problem in SCO OpenServer 5.0.5.
To resolve this for SCO OpenServer 5.0.4, follow these steps:
1. Type "custom". Highlight only the "Release Supplement for SCO OpenServer Release 5.0.4" and press <Enter>.
2. Scroll down to the network driver appropriate for your network
card and press the "space" bar to select it. Be sure that the
driver is the only selection chosen (if the full rs504c is
still selected the "space" bar can be used to select and
deselect software packages and/or drivers). Select "Software"
from the header choices, followed by "Remove Software". Be sure
that the network card driver is the only selection to be removed.
Then select "Remove".3. Once the driver has been removed and the kernel relinked,
restart the system. (To relink the kernel, exit the software
manager and change directories to "/etc/conf/cf.d" and enter
"./link_unix").4. Run "netconfig", select the network card. Then choose
"Hardware" from the header choices, followed by "Remove network
device". Once the network adapter software has been removed
and the kernel relinked, restart the system.5. Re-run "netconfig" to add the network card. Select "Hardware",
then "Add new LAN adapter". Once the network card has been
added and configured, the kernel will be relinked. Restart
the system.The network should now be operational assuming the network was properly configured.
NOTE: Below is an alternate method. However, it involves removing
Release Supplement 504C. It is _not_ recommended.The following steps are for removing rs504c and reinstalling the network adapter:
1. Type "custom" and select the "rs504c" software. Select
"Software" from the header choices. Then select "Remove
Software" and then "remove".2. Once Release Supplement 504C is removed and the kernel is relinked, restart the system.
3. Type "netconfig" and select the network adapter. Then select
"Hardware" from the header choices. Select "Remove network
device" and then select "yes".4. Once the network card has been removed and the kernel is relinked, restart the system.
5. Re-run "netconfig" and select "Hardware", followed by "Add new LAN adapter". Configure the network card, relink the kernel and restart the computer.
6. The hardware configuration screen should no longer show the error listed above. The network should be functional, if the network card was properly configured.
See also
ta105811, "What is the Release Supplement 504C for SCO OpenServer Release 5.0.4 (RS504C)?"