Problem
The Intel EtherExpress Pro/100B NIC and the eeE MDI version
1.2.0 driver is configured in a machine. I'm seeing at or near
100% error rate on outgoing packets.The output of "netstat -i" shows that "Oerrs" are equal to "Opkts". This means that the number of outbound errors is equal to the number outbound packets.
When the NIC is explicitly configured for "10Mbs" operation the
physical interface is configured to operate in sync mode. In
most cases this is incorrect. Most available hubs and switches
are async devices. The extremely high error rate is a result
of the driver being set for sync operation when connected to
async network hardware. Solution
The eeE driver can be configured for "auto", "10Mbs", or
"100Mbs" operation. In auto mode the card determines the speed
of the network and whether to operate in "sync" or "async"
mode. Use the program "netconfig" and select the driver for
the Pro/100B. Select "configure", and use the "Advanced
Options" to select the "Auto" option. Exit netconfig and
rebuild the kernel when prompted. Reboot the system.Driver version 1.2.0 was previously available as TLS595 on the
SCO web site. Version 1.2.0 has been relocated to the AHS area
on the sco web site and has a 07 Mar 97 date on the floppy
label. The directory containing eeE MDI is:/AHS/5.0/sco/new/pro100bThe site is ftp.sco.com or www.sco.com.A newer driver will be released. By default it will initialize
to async operation when "10Mbs" is selected. See also
TA101579 "Which Intel networking products are supported in the SCO environment?"
TA107622, "Intel EtherExpress Pro/100 or Pro/100B NIC isn't working."
TA101596, "Using Intel Pro/100B NIC: 'WARNING: eeE: Allocb failure during initialization'".