Problem
How can I install OpenServer on a Compaq Proliant which is unable to load the Compaq SmartStart CD?
When booting using the Compaq SmartStart CD, the "Compaq SmartStart" logo is displayed then the screen goes dark and the following message appears:
Unable to load Compaq SMARTSTART. Error 11 Check CDROM or CD-Drive for errors.
I am unable to configure the hardware of my Compaq server or build any logical drives on any Compaq SmartArray RAID controllers that are installed.
Cause
There is likely to be a hardware problem with the CD-ROM, on-board Compaq SCSI Controller, or with the SCSI lead connecting the CD-ROM.
Solution
a) Replace the faulty hardware with either Compaq equipment or by adding a third party SCSI controller and connecting the CD-ROM to it.
b) Build the Compaq Proliant using floppy disks.
These can be generated from either https://www.hpe.com or from the Compaq SMARTSTART CD. To use the SMARTSTART CD, use the following steps:
- Insert the CD into a PC running a flavor of Windows95 using a CD Drive that supports Autostart
- Select the option to create Support Disks.
You will need:1. The Compaq System Erase UtilityThis disk is bootable and will flush the BIOS config
of your server. This may also fix any reported
hardware faults that your Compaq is claiming to have.
It will also remove any logical disk configuration
from any Compaq SmartArray controllers installed.2. The Compaq Test & Inspect UtilityThis disk is bootable and will test the installed
hardware. It can also be used to low level format
any drives found. See ta105645, "How do I perform a
low level format on a SCSI hard drive on a Compaq
Server?"3. The Compaq System Configuration disksThese four disks are bootable and, when run initially
after a System Erase, will configure the BIOS of your
server. After a second boot you will see the Compaq
System Config main menu where you can run <CTRL> A
for the Advanced mode.4. The Compaq Array Config disksHere you can also configure the Drive Array in the
System Configuration menu. These disks are only
available from the Compaq SMARTSTART CD and not the
Compaq Web site.These two disks are bootable and you will be prompted for them. The server will reboot to use them and expand the FILESx.EXE files on them into its RAMDISK.
You can then also configure your drive array.
5. ROMPAQ's can be added separately if you require to upgrade the server's firmware.
6. You will now be able to install OpenServer using the floppy boot disk and CD provided.
The Compaq SMARTSTART CD will contain the appropriate
EFS (Extended Feature Supplement) for your operating
system, including SCO Unix 3.2v4.2 and SCO UnixWare
2.1.X. See also
ta105645, "How do I perform a low level format on a SCSI hard drive on a Compaq Server?"
ta105292, "Does the Compaq ProLiant 5000 work with SCO Open Server?"
ta109821, "Compaq Proliant with SCO OpenServer 5.0.x: SMP doesn't see my second CPU."