Technical article 109821

Compaq Proliant with SCO OpenServer 5.0.x: SMP doesn't see my second CPU.

OpenServer 5.0.0OpenServer 5.0.2OpenServer 5.0.4OpenServer 5.0.5OpenServer 5.0.6

Written · Last revised

Problem

After installation and licensing of the SMP product, only one CPU continues to be recognized. This is confirmed by running the hw command.

Cause

The Compaq SmartStart CD-ROM configures the system for IntranetWare/Netware, regardless of the operating system that is being installed. This may lead to compatibility problems with the SCO SMP (Symmetrical Multiprocessing) product.

There are also APIC configuration options in the Compaq System Configuration Utility which may influence SMP compatibility.

Solution

Following are two solutions that have been known to work:

(1) In the Compaq System Configuration Utility:

Select "View or Edit Details".

Go to the "Primary Operating System" option.

Select UNIX, then SCO.
Save the system configuration settings.
Install SCO OpenServer 5.0.4 using normal installation
instructions.
Reboot after installation.
Install the SMP package using normal installation
instructions.
Reboot after installation.

The system should see the additional processors.

(2) Also in the System Configuration Utility:

Enter <Ctrl>A to go to Advanced Mode.

Scroll down to APIC mode select and highlight:

                   Change mode to Full table - Mapped
NOTE:     For multiprocessor support, here is a list of recommended supplements
          for the various releases of SCO OpenServer:
On OpenServer 5.0.5:
--------------------

The correct order of the installation is: - Install SCO OpenServer 5.0.5. - Install Symmetrical Multiprocessing (SMP). - Install Release Supplement 505A (rs505a). - Install SLS OSS497C.

On OpenServer 5.0.6:
--------------------

The correct order of the installation is: - Install SCO OpenServer 5.0.6. - Install Symmetrical Multiprocessing (SMP). - Install Release Supplement 506A (rs506a). - Install SLS OSS648A

It is recommended to reboot the server into Single-User mode after installation of SMP, a Release Supplement and an SLS package.

See also

ta105898, "SCO OpenServer IFS 5.0.4 system doesn't see any additional CPUs even though SMP is licensed properly."

ta105363, "SCO SMP 5.0 does not work with SCO OpenServer Desktop System Release 5."

ta109975, "What is SLS OSS469C, the Networking and SMP Supplement for OpenServer 5.0.4?"

ta109741, "What problems are addressed by OSS491A, the Kernel and SMP Supplement for OpenServer 5.0.5?"

ta105708, "What is SLS OSS458A, the Intel Processor Supplement for OpenServer 5.0.2?"

From the Xinuos technical article database, record 109821. Reproduced with permission. The original is at www.sco.com/ta/109821, which is reachable but blocked from search engines. Xinuos marks this article against a retired product line. That refers to the product’s lifecycle, not to whether the advice still works — plenty of it still applies to running systems.

Next step

Need this fixed rather than explained?

Tell us the release, what the system runs and what it is doing. We will reply by email with what we would do next.

  • You deal with the people who do the work
  • No obligation, and no upgrade required before we will help
  • We tell you plainly if something is not worth doing

Send an enquiry

We reply by email. If a server is down, say so in the first line. You can also write to help@scoexpert.com.