Technical article 125947

My HP ProLiant G4 panics when a USB 2.0 device is on the system.

OpenServer 5.0.7

Written · Last revised

Problem

I am experiencing panics on my Openserver 5.0.7 system when I have a USB 2.0 device plugged into the machine. This is occurring either during installation, at normal system boot, or when the device is hot-plugged into the system. I am seeing panic messages such as the following:

FATAL: Parity error on the motherboard. WARNING: Parity error address unknown.

NOTICE: k_trap - Unexpected NMI in system mode! T.6726-usbd0 001D7 <Drvr16>: Illegal device descriptor received during enumeration!

This is usually followed by system double panic.

HARDWARE: Any USB 2.0 capable device

Solution

A fix was included in Maintenance Pack 3 that resolves the above panics which can be downloaded from

http://www.sco.com/support/update/download/osr507list.html

If you have already installed OpenServer 5.0.7, you can simply apply the above Maintenance Pack to resolve the issue.

In the case of a new installation, you can work around the problem in one of the 2 following ways

1. Unplug any USB 2.0 capable devices from the system and
proceed  normally through the installation of the
Operating System and Maintenance Pack 3.
OR

2. Use the following boot parameter to disable the USB 2.0 driver for the installation:

defbootstr disable=usb_ehci
On the subsequent boot of the system, enter the above
disable bootstring again at the boot prompt to prevent the
system from panicing. Once the system comes up, apply
Maintenance Pack 3 and reboot and the USB 2.0 device(s)
should no longer cause this problem.

See also

TA125771, "SCO OpenServer Release 5.0.7 Maintenance Pack 3 Release and Installation Notes"

bootstring(HW)

From the Xinuos technical article database, record 125947. Reproduced with permission. The original is at www.sco.com/ta/125947, which is reachable but blocked from search engines.

Next step

Need this fixed rather than explained?

Tell us the release, what the system runs and what it is doing. We will reply by email with what we would do next.

  • You deal with the people who do the work
  • No obligation, and no upgrade required before we will help
  • We tell you plainly if something is not worth doing

Send an enquiry

We reply by email. If a server is down, say so in the first line. You can also write to help@scoexpert.com.