Problem
When trying to add a tape drive through `mkdev tape`,
there is no option to add a USB tape drive. Is there
anyway that the USB tape drive can be configured?HARDWARE: USB tape drives Solution
The `mkdev tape` command does not have a USB option directly, but
the tape drive can be added as a SCSI tape drive by following the
steps below.NOTE: Be sure that you have Maintenance Pack 5, or higher, installed.NOTE: Disconnecting and re-connecting the USB devices can
cause assignment of new USB ID information and cause the
USB tape drive and other USB configurations to become
invalid. Therefor it is suggested that you try to have
all USB devices connected in their permanent place before
you configure any of them. It is also suggested that the
devices be connected prior to booting the system.With the USB tape drive connected, boot to multi-user mode and login as root.
Find the USB ID assignments for the tape drive using:
sconf -vYou should see an Stp line that begins usb_msto which indicates how the USB tape drive was detected, it should look similar to:
Stp usb_msto 0 1 2 0The 4 numbers that follow are in the order of: adapter #, bus #, target id #, and lun #
With this information you can add the tape drive to the system using:
mkdev tapeAdd the tape drive as a SCSI tape drive. When prompted
for the prefix of the SCSI host adapter that supports the
device use 'usb_msto', and the adapter #, bus #, target id
#, and lun # shown by sconf. Choose 'q' to quit the
questions about Vendor identification string and the boot
string.Relink the kernel when prompted after quitting from the mkdev menu.
Reboot the system and test the tape drive.
ACKNOWLEDGMENTS:The solution to this problem was contributed by: Steve Moritsugu from DTR Business Systems