Problem
I have installed, configured and booted my SCO OpenServer 5.0.7V for the VMware Virtual Appliance and I have the scologin GUI open on the virtual console.
What key sequence should I use to switch between the 12 console mulitcreens?
Solution
Switching between OpenServer 5.0.7 console multiscreens is usually achieved by pressing the key sequence:
<Ctrl><Alt><Fn>where if, for Fn, you press F3, you are switched to multiscreen 3.
A total of 12 multiscreens are supported and implemented.
This same key sequence can be used when running on a virtual console connected to an ESX or ESXi server.
However, if you are running SCO Openserver 5.0.7V on VMware Workstation 6.5.2 the key sequence:
<Ctrl><Alt>is the mouse defocus and because of this you cannot switch multiscreens on an Openserver 5.0.7V console running on VMware Workstation 6.5.2 and VMware Vsphere 4.1:
To workaround this problem you either:1) Use the key sequence:<Ctrl><Alt><Spacebar>, release <Spacebar> and then press <Fn> (while continuing to press <Ctrl><Alt>)
ie. Ctrl-Alt-Space-Fnor:2) Under VMware Workstation select:Edit -> Preferences -> Hot Keysand reprogram the Hot Key combination to something other than
<Ctrl><Alt>.This will then allow you to use the:
<Ctrl><Alt><Fn>sequence to switch multiscreens.NOTE: CTRL-ALT-Space Fn is only needed when moving from the GUI
(usually in tty02) to a text-based console.When moving from a text-based console to another text-based consoles pressing CTRL-ALT-Fn works as before without needing to press the SpaceBar.