Problem
I am receiving panics with "PANIC: k_trap kernel mode trap type 0x0000000F" at random intervals during installation.
Cause
It could be possible that there is a hardware problem with the server.
Solution
Check the following to ensure that the server is correctly configured:
a) Perform a BIOS check. You may wish to reset the BIOS to the
default values, disable the internal/external CPU cache to see
if OpenServer will install if the server runs slower.In 3.2v4.2 there is also a "cache=/n" bootstring parameter. More detail is given on this issue in ta104329, "Generic advice for installing SCO UNIX operating system."
If the disk is IDE, set the BIOS IDE to run slower, less efficiently. You may have to reduce the cylinder size from 1024 to 1023 for IDE disks to install 3.2v4.2.
Check the PCI Interrupts to ensure that none can be allocated over ISA interrupts, which can cause a conflict.
If applicable, try turning off the built-in Power Management monitoring.
Check with your manufacturer to see if there is a new BIOS available.
b) Check to see if there are any dip switches on the motherboard. If the original documentation is not available, visit the following website for more information:
http://www.motherboards.orgc) Perform a Low Level format of the disk drive.
d) Check the leads, cabling, RAM and processor seating inside the server.
See also
ta104329, "Generic advice for installing SCO UNIX operating system."
ta105303, "My Pentium Pro panics with "PANIC: k_trap kernel mode trap type 0x0000000F.""