Technical article 125912

OpenServer 5.0.7 - "CPU 2 Boot Failure" Warning on Intel Xeon MP systems

OpenServer 5.0.7

Written · Last revised

Problem

After installing SMP on my Intel Xeon-based system in order to
activate the second CPU, I get "WARNING: CPU 2 Boot Failure" on
startup.  The second CPU fails to activate, and the system boots up
with only the primary CPU.
HARDWARE: SMP multiprocessor Intel xeon-based systems with USB

Solution

This has been reported to SCO Engineering.

It is possible that the above failure may be worked around in one of the three following ways:

1) Make sure Maintenance Pack 3 (MP3) is installed.  MP3 should
   be installed on top of SMP.  Note that if MP3 is installed
   immediately after SMP, without an intervening reboot, the
   problem may never be seen.

2) If USB devices are attached, try the following bootstring:

defbootstr swap=none
After booting up successfully, you can re-enable the default
swap area (usually /dev/swap) with the commmand
"swap -a /dev/swap".

3) If do not need to use USB devices, or if the above attempt fails, try the following bootstring:

defbootstr disable=usb_ohci

Note: if either of these workarounds are successful, then the corresponding boot options can be placed in the /etc/default/boot file to allow subsequent boots to function properly.

NOTE:     The last two workarounds are the same ones described in
          the Late News section of the release notes at
http://docsrv.sco.com:507/en/LateNews/LateNews.html
BUT for a different problem.  In the Late News, the two above
workarounds pertain to a panic at boot time.
NOTE:     In addition, hyper-threading support in the BIOS must be
          turned off when using Xeon processors (also described in
          the Late News).
NOTE:     The SMP package should be installed immediately
          after system installation and prior to the installation
          of any other package and/or update/maintenance pack.
NOTE:     There is an unconfirmed related issue with the Adaptec
          ASR2120S--if you have a multi-processor system with this HBA and
          experience the above problem, you may wish to consider the following
          actions, with results as noted:

* Downgrade the BIOS in the ASR2120S to 6011

* The next boot may cause a BIOS panic in the ASR2120S
which sorts itself out on next boot (you may need to go
into RAID BIOS and manage arrays to allow a new rebuild as
the older BIOS has a slower build function.  This does NOT
destroy any data).

* You may receive the message "NMI ISR: NMI_PRIMARY_ATU_ERROR", this can be safely ignored (transient inability to access PCI bus at start up, but since you see the message the device actually has successfully accessed the bus).

* Upgrade the ASR2120S BIOS to 7244

From the Xinuos technical article database, record 125912. Reproduced with permission. The original is at www.sco.com/ta/125912, which is reachable but blocked from search engines.

Next step

Need this fixed rather than explained?

Tell us the release, what the system runs and what it is doing. We will reply by email with what we would do next.

  • You deal with the people who do the work
  • No obligation, and no upgrade required before we will help
  • We tell you plainly if something is not worth doing

Send an enquiry

We reply by email. If a server is down, say so in the first line. You can also write to help@scoexpert.com.