Technical article 126819

OpenServer 5.0.7 detects my disk but does not display its capacity correctly.

OpenServer 5.0.7

Written · Last revised

Problem

While installing or configuring an new disk with OpenServer 5.0.7, the operating system sees the disk but the capacity of the disk that is seen is only a small percentage of the actual size of the disk.

Cause

The cylinder limit in the OpenServer 5.0.7 disk geometry is 65535.

The exact geometry is determined by the specific disk controller driver that you are using.

Most SCSI Drivers use 255 heads and 63 sectors/track for large disks. Multiplying all the maxima:

65535 * 255 * 63 * 512 bytes/sector

gives a maximum disk size of 539043724800 bytes or about 539GB.

Solution

The maximum capacity of a single disk that can be recognised by OpenServer 5.0.7 is dependent on the disk driver being used to control the disk.

Many SCSI Controller Host Bus Adapter (HBA) Drivers supported with OpenServer 5.0.7 are limited to recognising just over 539GB of disk capacity.

If you present a physical or logical drive that is say 600GB size to one of these drivers then OpenServer 5.0.7 will only see a disk of 61Gb in size (i.e. 600Gb-539Gb).

The wd disk driver (BTLD) included in Supplement CD 5 has been tested with IDE disks up to 1Tb in size and theoretically can support IDE disks up to 2Tb in size.

Supplement CD 5 is available to download from:

http://www.sco.com/support/update/download/release.php?rid=187

If you have a SCSI based system where you are not seeing the full capacity of the disk at install/configuration time, and the disk is greater than 539GB in size your options are:

1) If you are using Hardware RAID to build the Primary disk try using a logical disk size that is less than 539GB to see if this solves the problem

2) If you are using a single SCSI disk that is greater than 539GB in size then replace it with a primary disk less than 539Gb in size

3) If you have the option to use an IDE controller and disk as the primary controller and disk on your system instead of SCSI then this may be an acceptable alternative in some cases

4) Upgrade to OpenServer 6.0.0 which does not have these disk size limitations.

See also

TA#118463 "Are there any disk and filesystem size restrictions in OpenServer 5?"

From the Xinuos technical article database, record 126819. Reproduced with permission. The original is at www.sco.com/ta/126819, which is reachable but blocked from search engines.

Next step

Need this fixed rather than explained?

Tell us the release, what the system runs and what it is doing. We will reply by email with what we would do next.

  • You deal with the people who do the work
  • No obligation, and no upgrade required before we will help
  • We tell you plainly if something is not worth doing

Send an enquiry

We reply by email. If a server is down, say so in the first line. You can also write to help@scoexpert.com.