Technical article 126668

OpenServer 5.0.7 does not recognize the full drive capacity on HP logical drives

OpenServer 5.0.7

Written · Last revised

Problem

I am installing OpenServer 5.0.7 on a HP Proliant system with a logical drive array that is >250Gb in size, the OpenServer installation does not recognise the full drive capacity.

Solution

For a solution to this problem please see:

http://h200003.www2.hp.com/bizsupport/TechSupport/Document.jsp?lang=en&cc=es&taskId=110&prodSeriesId=254931&prodTypeId=15351&objectID=PSD_EU041208_CW01
ie.:
Description

A ProLiant server running SCO OpenServer 5 will display a drive size that is significantly smaller than expected under all of the following conditions:

The server is configured with an array logical drive. The capacity of the logical drive is greater than 255 GB. The Array Configuration Utility (ACU) Version 7.10 default parameters are used to configure the array.

If the logical volume is configured using Option ROM Configuration for Arrays (ORCA) Utility, the drive size is displayed as expected under SCO OpenServer 5.

The difference in drive parameters between ORCA and ACU is that ORCA sets the logical number of sectors / track at 63, whereas ACU sets it as 32. If the MAX BOOT parameter in ACU is enabled, the number logical number of sectors/track is set to 63; therefore, SCO OpenServer 5 will correctly identify the drive capacity

Resolution

For SCO OpenServer 5 to recognize the correct drive size, perform either of the following:

Use ORCA to configure the drive array.  To invoke ORCA press F8 when
the message "Press F8 to run the Option ROM Configuration for Arrays
Utility" is displayed.
OR

Enable the MAX BOOT parameter when creating a volume greater than 255 GB under ACU when using SCO OpenServer 5.

NOTE:     This issue has also been worked-around by using the "biosgeom" boot
          string in the format:  biosgeom=(x,x,x) after "defbootstr" at boot
          time and in /etc/default/boot

OpenServer 5.0.7 does have a limitation of 500Gb disk size with SCSI.

Use the latest "wd" version on SATA disks which overcomes this restriction.

From the Xinuos technical article database, record 126668. Reproduced with permission. The original is at www.sco.com/ta/126668, which is reachable but blocked from search engines.

Next step

Need this fixed rather than explained?

Tell us the release, what the system runs and what it is doing. We will reply by email with what we would do next.

  • You deal with the people who do the work
  • No obligation, and no upgrade required before we will help
  • We tell you plainly if something is not worth doing

Send an enquiry

We reply by email. If a server is down, say so in the first line. You can also write to help@scoexpert.com.