Problem
I have an external tape drive connect to my HP/Compaq Proliant server. Watching the system boot during the BIOS information, the device is recognized at "Port 2", SCSI ID 6. I have tried various combinations with "mkdev tape", but none seem to be the correct location.
Solution
On some HP/Compaq Proliant servers, such as some versions of the DL380 and DL580, the external SCSI port is actually a port for the onboard Smart Array RAID controller. These host bus adapters are controlled by the ciss or clad drivers which are supplied as part of the HP Extended Feature Supplement (EFS) (later Openserver 5 versions have these drivers included in the installation media). You can determine which your system has by looking at the "hwconfig -h" output to see what driver your disk(s) are using. "Port 2" is presented to Openserver as the 3rd SCSI bus on this controller. Hence, the values you will need to supply in these cases are:
prefix of the SCSI host adapter clad
Host Adapter Number 0
Bus 2
SCSI ID 6
LUN 0orprefix of the SCSI host adapter ciss
Host Adapter Number 0
Bus 2
SCSI ID 6
LUN 0NOTES: It is generally not recommended to install tape drives on RAID controllers. Check with HP/Compaq Support as to whether yours is a supported configuration. If possible, install the tape drive on a standard SCSI controller.
go to:http://h18007.www1.hp.com/support/files/server/us/index.html for the latest Extended Feature Supplement.
Online documentation for adding tape drives:
http://docsrv.sco.com:507/en/HANDBOOK/tape_drive_installing.html
http://docsrv.sco.com:507/en/HANDBOOK/SCSI_tape_installing.html