Technical article 104844

Re-installing various boot files onto my hard disk on OpenServer 5.0.x

OpenServer 5.0.0OpenServer 5.0.2OpenServer 5.0.4OpenServer 5.0.5OpenServer 5.0.6OpenServer 5.0.7

Written · Last revised

Problem

My system is failing to boot to the Boot: prompt and I believe that the Masterboot or Partition Boot Blocks may have been damaged. How do I install the various boot related files from my filesystem to the appropriate blocks on the hard disk?

Solution

If you cannot boot from the hard disk, boot from a bootable floppy disk and root from the hard disk using this command at the Boot: prompt:

hd(40)unix

Enter Single-User Mode and issue these commands:

instbb hd /dev/hd0a
dparam -w

The instbb(ADM) command writes the Partition Boot Blocks (/etc/hdboot0 and /etc/hdboot1) to the hard disk. The dparam(ADM) command writes SCO's Masterboot Code to the Masterboot Block on the hard disk.

For some disks it may also be necessary to stamp the disk
geometry onto the first disk using dparam(ADM).  Please refer
to the dparam(ADM) manual page for details on how to do this.

See also

TA104844, "Get "Stage1 boot failure: error loading hd(40)/boot" after installation of SCO Openserver 5.0.7."

From the Xinuos technical article database, record 104844. Reproduced with permission. The original is at www.sco.com/ta/104844, which is reachable but blocked from search engines.

Next step

Need this fixed rather than explained?

Tell us the release, what the system runs and what it is doing. We will reply by email with what we would do next.

  • You deal with the people who do the work
  • No obligation, and no upgrade required before we will help
  • We tell you plainly if something is not worth doing

Send an enquiry

We reply by email. If a server is down, say so in the first line. You can also write to help@scoexpert.com.