Technical article 105826

SCO OpenServer 5.0.4 installation hangs during hard disk initialization.

OpenServer 5.0.0OpenServer 5.0.2OpenServer 5.0.4

Written · Last revised

Problem

I am installing or upgrading to SCO OpenServer 5.0.4. The installation hangs after the hardware table is displayed. This is when the hard disk gets initialized. Why is this happening and how can I get around it?

Cause

With certain hardware setups, the SCO OpenServer 5.0.4 kernel will continue searching for install devices even after it has detected the primary hard drive. At times the search will loop, causing the installation to hang.

Solution

If your CD-ROM and primary hard drive are SCSI, at the Boot: prompt, type:

Boot: defbootstr scsi.noscan

If your CD-ROM is IDE, at the Boot: prompt, type:

Boot: defbootstr wd.noscan

If neither of these solutions remedies the problem, check for IRQ conflicts.

NOTES:    If the system has an Adaptec 2940 SCSI controller card, and
          you are experiencing a hang during installation, see TA105679,
          "Problems with the alad driver in OpenServer 5.0.4 is causing my
          system to hang" for instructions on using an updated alad driver
          for installation.

See also

TA105741, "My 5.0.4 install fails with 'Warning no controller response on SCSI adapter...'"

From the Xinuos technical article database, record 105826. Reproduced with permission. The original is at www.sco.com/ta/105826, which is reachable but blocked from search engines. Xinuos marks this article against a retired product line. That refers to the product’s lifecycle, not to whether the advice still works — plenty of it still applies to running systems.

Next step

Need this fixed rather than explained?

Tell us the release, what the system runs and what it is doing. We will reply by email with what we would do next.

  • You deal with the people who do the work
  • No obligation, and no upgrade required before we will help
  • We tell you plainly if something is not worth doing

Send an enquiry

We reply by email. If a server is down, say so in the first line. You can also write to help@scoexpert.com.