Problem
When performing an initial OpenServer 5.0.x installation, the installation software provides the user several options to scan the hard drive(s) for bad tracks. Bad track scanning is used to find and keep track of the bad tracks on the hard disk and to map bad tracks to good tracks elsewhere on the disk.
Bad track checking is a conservative option, and the default "Thorough/Destructive" is the most conservative choice of all. Using modern disk drives, bad track checking is generally not required, even on a new hard drive. However, performing bad track checking can take several hours, depending of the type of checking and the size of the hard drive. In particular, the "Thorough/Destructive" option may take many hours to complete.
Solution
An OpenServer 5.0.x initial system installation uses bad track scanning as the default choice and the default scanning type is "Thorough/Destructive". To avoid the significant delay caused by the default bad track scanning option, the user simply needs to either select a less time-consuming scanning option or--as most users do--select the option "None" and do no bad track scanning at all.
The track scanning settings are found on the screen labeled:
"Preparing your disk and choosing software"during the interactive installation process.This screen presents the default option to perform bad track checking:
Hard disk setup: UNIX only : Bad Tracking ONIf the user positions the cursor on this field and presses the Space Bar, the screen display changes to present the user with options for bad track checking:
Disk 0 bad track type: Thorough/Destructive(Note: the above screen text is only an example; other disk configurations would be displayed accordingly.)
Place the cursor over this field and press the Space Bar to see all bad track checking options:
None
Thorough/Destructive
Thorough/Non-Destructive
Quick/Destructive
Quick/Non-DestructiveAs discussed above, bad track scanning adds to installation time and is generally not required. The default choice adds the most delay of all. For these reasons, you may choose to select "None" as the bad track scanning option, or to carefully consider the other bad track checking options before proceeding with the installation.