Problem
What LSI Logic Host Adapters are supported by the lsil Host Bus Adapter driver?
NOTE: This driver package is to be installed on:SCO OpenServer 5.0.6a, 5.0.7 Solution
These drivers are available at the following URL:
https://ftp.scoexpert.com/openserver5/507/drivers/lsil_1.03.28/Modification History
********************
5.0.6, 5.0.7 - Updated driver version from 1.03.27 to
1.03.28, 9/14/04
Changes from 1.03.27:
o Check Nvram data and limit Domain Validation activities
if requested.
Defect fixes:
o Accommodate disk drives with capacity greater than 64 GB********************To install these drivers, follow these instructions:
1. Acquire the driver from the ftp address listed above.
- Download the btld image to a directory/file on your machine. For example, /tmp/lsil.btld.img
- Verify the downloaded image using sum.
sum -r /tmp/lsil.btld.imgThis should return:50483 2880 /tmp/lsil.btld.img- Format a floppy disk using the format command.
- Copy the downloaded image to the floppy:
dd if=/tmp/lsil.btld.img of=/dev/fd0 bs=18k- Verify the copied floppy image using sum:
sum -r /dev/fd0This should return:50483 2880 /dev/fd02a. Fresh Installation on Primary Drive- Insert a boot disk or Installation CD and boot the system.
- At the boot prompt, type:defbootstr link=lsil- Press <Return> and continue with normal installation.
2b. Installation on a Secondary Drive- Boot and Login normally.- Mount the floppy image:mount -r /dev/fd0 /mnt- Use the BTLD Install script to install the driver:
/etc/btldinstall /mntOnce the kernel has been relinked, reboot the host and verify that is initializing the card. The boot time banner should look something like:
%adapter 0xec00-0xecff 11 - type=lsil ha=0 slot=0 bus=0 id=7 fts=stoWhen the adapter is installed and the boot-time banner is properly displayed, you may use the appropriate mkdev script to add a disk, tape, or cdrom to the SCSI and/or Fibre Channel Bus.
NOTE: You will not be able to use this driver to perform a fresh install
of OpenServer 5.0.6.The new v1.03.28 BTLD driver consumes more memory than has been
allocated for 3rd party drivers on the OpenServer 5.0.6 Installation
Boot Disk. This is why you are likely to see a memory error message
when the BTLD is loaded.There is more memory allocated to 3rd party drivers on the OpenServer 5.0.7 Installation Boot Disk which means you can use this to install OpenServer 5.0.6.
The README indicates the driver is for 5.0.6a and 5.0.7 which implies that for 5.0.6 it would be an upgrade to an existing installation.
You are using the 5.0.7 Installation Boot Disk only to boot the server to perform the initial system load (ISL) of the server and as a result no 5.0.7 binaries are placed on your installation.