Technical article 125736

When I try to load OpenServer 5.0.7 on an IBM xSeries 255 with ServeRAID 6m, it hangs at hd_config when booting.

OpenServer 5.0.4OpenServer 5.0.5OpenServer 5.0.6OpenServer 5.0.7

Written · Last revised

Problem

When doing a fresh installation of SCO OpenServer 5.0.7 on an IBM xSeries 255 with a ServeRAID 6m controller, all appears to go well. The ipsraid btld driver loads from the floppy disk, but when the system tries to boot, it hangs at the hd_config message. After 3-4 mins at that stage, the following message repeats itself on the screen until a cold boot is performed.

ips0 resetting Controller

HARDWARE: IBM xSeries 255 with ServeRAID 6m SCSI controller.

Cause

There are firmware issues with some of the xSeries servers & ServeRAID cards.

Solution

Make sure that the ServeRAID driver and firmware releases for *both* the controller *and* system are current.

The following link will show which firmware updates and drivers are available for ServeRAID running on OpenServer;

http://www-1.ibm.com/support/docview.wss?1=xseries+255+serverraid&uid=psg1MIGR-39737&loc=en_US&cs=utf-8&cc=us〈=en

You should update your system's firmware from the IBM site (http://www.ibm.com) as appropriate.

NOTES:    It has been observed that updating the ServeRAID
          controller firmware by itself was *not* sufficient to
          resolve the problem.

See also

TA125303 "How do I add a tape on the second channel of an IBM ServeRaid 5I or 6M controller?"

TA125516 "My Openserver 5 system reports "Bad EEPROM read" for the eeE driver when running hwconfig."

From the Xinuos technical article database, record 125736. Reproduced with permission. The original is at www.sco.com/ta/125736, which is reachable but blocked from search engines.

Next step

Need this fixed rather than explained?

Tell us the release, what the system runs and what it is doing. We will reply by email with what we would do next.

  • You deal with the people who do the work
  • No obligation, and no upgrade required before we will help
  • We tell you plainly if something is not worth doing

Send an enquiry

We reply by email. If a server is down, say so in the first line. You can also write to help@scoexpert.com.