Technical article 104717

Does SCO OpenServer Release 5.0 support EIDE hard disks?

OpenServer 5

Written · Last revised

Problem

Previous releases of SCO Open Server/Open Desktop or SCO UNIX
System V/386 Operating System did not include support for EIDE
hard disks.  Will they work with SCO OpenServer 5.0?

Solution

SCO OpenServer Release 5.0 supports the use of Extended IDE disk
drives (generally IDE drives with a capacity greater than 528Mb)
both with and without Logical Block Addressing (LBA).  LBA allows
a disk's geometry to be rearranged by the BIOS so that partitions
that extended past 528Mb are still bootable.

LBA is a feature of the system's BIOS and is only available on systems with BIOS LBA support. To enable LBA it is necessary to enter the system's setup mode and configure the appropriate option (see the system's hardware documentation for instructions).

If more than one drive is to be used, SCO recommends that all
drives are similarly initialized.  That is, all drives should
have LBA enabled or all drives should have LBA disabled.

Support for multiple drives where some drives use LBA and some do not is BIOS dependent and will vary between systems.

If the disk is unused, or has previously been used with LBA enabled, SCO OpenServer Release 5.0 can be installed immediately. If the disk drive has previously been used without LBA enabled and it is necessary to install with LBA, the disk parameter table must be deleted.

Use the following procedure to delete the disk parameter table for the root hard disk:

1. Boot the system with the install floppy.

2. Type "tools" at the boot prompt, followed by any other boot string options required to install your system.

3. Select installation media and continue as per a normal installation.

4. Select "1) Execute a shell on ramdisk filesystem".

5. Type the following at the shell prompt:

"dd if=/dev/zero of=/dev/rhd00 bs=1b count=1"
6. Switch off the system.

7. Switch on the system and then install as normal.

Use the following procedure to delete the disk parameter table for a secondary disk with a root IDE controller (note that this should be done BEFORE running using scoadmin(ADM) or "mkdev hd" to configure the system to use the secondary disk):

1. Boot the system into single user mode.

2. Make a raw device node for the secondary disk. For the second disk this would be done with:

"mknod /dev/tmp_node c 1 64"

For other disks the minor device number (the 64 in the above line) should be replaced with the correct minor number for that drive (128 for the 3rd drive and 192 for the 4th drive).

3. Use the following to delete the disk parameter table:

"dd if=/dev/zero of=/dev/tmp_node bs=1b count=1"

4. Remove the "tmp_node" device node ("rm /dev/tmp_node").

5. Reboot the system.

From the Xinuos technical article database, record 104717. Reproduced with permission. The original is at www.sco.com/ta/104717, which is reachable but blocked from search engines. Xinuos marks this article against a retired product line. That refers to the product’s lifecycle, not to whether the advice still works — plenty of it still applies to running systems.

Next step

Need this fixed rather than explained?

Tell us the release, what the system runs and what it is doing. We will reply by email with what we would do next.

  • You deal with the people who do the work
  • No obligation, and no upgrade required before we will help
  • We tell you plainly if something is not worth doing

Send an enquiry

We reply by email. If a server is down, say so in the first line. You can also write to help@scoexpert.com.