Problem
What video driver can I use to obtain higher resolution and color support greater than standard IBM VGA 640x480 16 colors for console?
NOTE: The generic VESA BIOS Extension (VBE) graphics driver detailed
below requires that these supplements be applied to the operating
system as follows:For SCO OpenServer 5.0.0 (in this order):
Release Supplement 5.0.0d (rs500d) Networking Supplement 1.0.0 (net100) SCO Advanced Hardware Supplement (AHS) 5.2
For SCO OpenServer 5.0.2:SCO Advanced Hardware Supplement (AHS) 5.2 (available on 5.0.2 CD media)
For SCO OpenServer 5.0.4 onwards:No additional supplements are necessarySupplements are downloadable from ftp.sco.com.You may install the 'Graphics' portion of SCO AHS 5.2 or just the Video Configuration Manager portion to obtain the minimal necessary graphics software to configure this driver.
Solution
Install the generic VESA BIOS Extension (VBE) graphics driver. This driver is available at the following URL:
https://ftp.scoexpert.com/driversTo install this driver, take the following steps:
1. Log in as root.2. Install SCO AHS Release 5.2 if not already installed.
This applies to SCO OpenServer 5.0.0 and 5.0.2 only.3. Download the volume image(s) to your machine to a directory,
for example, /tmp/vol.4. Run 'custom' and select 'Install New'. Install from your host
machine using 'Media Images'.5. Give the directory name where the volume images have been
downloaded, for example, /tmp/vol.6. Install the hardware into your computer.7. Run 'scoadmin video' and select the 'VESA' entry in the list
of supported video adapters. If a VESA entry is not available,
your system does not have a VBE compliant video adapter.NOTES: Device drivers for listed chip sets are certified to manufacturers'
reference circuitry. However, SCO drivers are not tested on all
hardware platforms and may not work for supported chip sets in
some hardware implementations. If you experience problems with a
particular chip set, contact SCO Support Services or your SCO
Software Supplier for more information.Additional VBE driver details:VBE 2.0 Video Adapters- Support of 256 and 64K colors at resolutions of 640x480 - 1600x1200 **
- A generic framebuffer XDriver is used to display graphics.
Because of the generic nature, this driver works on virtually
any modern graphics adapter. However, no chipset specific
accelerations are provided. Therefore, using high resolutions
or a high number of colors (that is, 64K) may cause a degradation
in performance depending on machine and video adapter speeds.VBE 1.2 Video Adapters- Support of 256 colors (only) at resolutions of 640x480 - 1024x768 **
- A windowed framebuffer XDriver is used to display graphics.
Color support is limited to 256 colors only. Resolutions are
limited to 1024x768 maximum. The degradations mentioned above
also apply here.** The actual resolutions and number of colors available depends
on the video adapter. Recommended mode to use is 1024x768 at 256
colors. Make sure your monitor supports this resolution prior to
configuring it.NOTE: When booting if you get a blank screen after the 'hwconfig' display
then it's likely your screen resolution is set to high for the
default console setting.Ensure 'scologin' is enabled and 'scoadmin video' is configured with the VESA Adaptor set to the lowest setting of 640x480 along with the correct Monitor size.
'vidi' can be used to change the 'font' size and the console screen type to 'vga' for all the console screens and many earlier types. The default is 'vga'. Setting an incorrect value may require the server to be re-booted (ie. access over the network) to reset it.