Technical article 126413

Host Bus Adapter (HBA) Driver Supplement - ahci Driver version 1.2

OpenServer 6.0.0UnixWare 7.1.4

Written · Last revised

Problem

What is the ahci Driver Supplement version 1.2 HBA for OpenServer 6.0.0 and UnixWare 7.1.4?

HARDWARE:

All of the AHCI v1.0 Specification is fully supported with the exception of port multipliers and power management.

All AHCI v1.0 compliant SATA controllers should work with this driver. Controllers based on the Intel ICH6M, ICH6R, ICH7M and ICH7R are known to work.

Solution

The ahci Driver Supplement provides the following driver:

ahci - SATA AHCI

Version 1.1 of this driver adds support for compliant SATA tape device.

Version 1.2 fixes a problem where the ahci controller assumes it is the primary/boot controller for the system when it is not resulting in a boot failure post ISL.

This driver can be used during fresh installation of any supported OpenServer 6/UnixWare 7 system or can be applied to an existing system.

The following driver is included in hba.ahci.1.2.image:

ahci

This image is available at the following URLs:

https://ftp.scoexpert.com/unixware7/714/drivers
https://ftp.scoexpert.com/openserver6/600/drivers
NOTE:
Native Hot-Plug support on UnixWare Release 7.1.4 requires
Maintenance Pack 3.  Without the proper Maintenance Pack
installed, Native Hot-Plug is not supported.

Maintenance Pack 3 for UnixWare 7.1.4 is available from:

http://www.sco.com/support/update/download/release.php?rid=126
-------------------------------------------------------------------------
I. Installation

While installing OpenServer 6/UnixWare 7 be sure to insert the ahci Driver Supplement diskette before any HBA drivers supplied with your media kit. Use the following steps on a OpenServer 6/UnixWare 7 system to create an HBA floppy from this image file.

1. Become root and create a new directory by typing:

$ su
Password: <type your root password>
# mkdir /tmp/hba
# cd /tmp/hba

2. Download the hba.ahci.1.2.image file to the newly created /tmp/hba directory on your machine.

3. Make an ahci HBA diskette from the image file using these command:

# dd if=hba.ahci.1.2.image of=/dev/dsk/f0t obs=36b

4. Use this ahci HBA diskette during system installation.

------------------------------------------------------------------------
II. Upgrading drivers on existing OpenServer 6/UnixWare 7 system

The ahci HBA diskette can also be used to upgrade the ahci driver on your system using the following command:

1. Insert the HBA driver diskette and type the command:

# pkgadd -d diskette1 all
or
# pkgadd -d diskette1 ahci
------------------------------------------------------------------------
III. Software Notes

This driver has been tested with and is supported on:

SCO UnixWare 7 Release 7.1.4 SCO OpenServer Release 6.0.0

From the Xinuos technical article database, record 126413. Reproduced with permission. The original is at www.sco.com/ta/126413, which is reachable but blocked from search engines.

Next step

Need this fixed rather than explained?

Tell us the release, what the system runs and what it is doing. We will reply by email with what we would do next.

  • You deal with the people who do the work
  • No obligation, and no upgrade required before we will help
  • We tell you plainly if something is not worth doing

Send an enquiry

We reply by email. If a server is down, say so in the first line. You can also write to help@scoexpert.com.