Technical article 126638

How can I change the controller order manually, similar to UnixWare 7 ISL DCU during installation of SCO OpenServer 6.0?

OpenServer 6.0.0

Written · Last revised

Problem

I have a server with multiple SCSI controllers in it. When I install SCO OpenServer 6.0.0, the ISL installation picks up the wrong SCSI controller as the boot controller.

Is there a way, similar to UnixWare 7 ISL DCU, to influence the boot controller order during the installation? In other words, is there a DCU in SCO OpenServer 6.0.0 Installation?

Solution

Yes, there is a DCU during the installation of SCO OpenServer 6.0.0.

To get to the OSR6 ISL DCU, continue the installation until you reach the ISL screen with:

Available Drivers - All Drivers Selected

In the bottom of the screen you will see that there is a F8 key for DCU "F8=DCU".

Press F8 and then choose "Interactively configure drivers".

This will then run DCU and you can then manipulate the SCSI controller order.

Save the changes in the DCU and you will be taken back to the OpenServer 6 installation screen to continue.

NOTES:    The other way to prevent SCO OpenServer 6.0.0 to be
          installed on the wrong SCSI controller, is to disable
          all NON boot SCSI controller BIOS and leave only the
          boot SCSI controller BIOS enabled.

From the Xinuos technical article database, record 126638. Reproduced with permission. The original is at www.sco.com/ta/126638, which is reachable but blocked from search engines.

Next step

Need this fixed rather than explained?

Tell us the release, what the system runs and what it is doing. We will reply by email with what we would do next.

  • You deal with the people who do the work
  • No obligation, and no upgrade required before we will help
  • We tell you plainly if something is not worth doing

Send an enquiry

We reply by email. If a server is down, say so in the first line. You can also write to help@scoexpert.com.