Problem
The server I am installing on does not ship with a floppy drive as part of the configuration.
How can I use a USB Floppy driver at installation time to install additional HBAs as part of an OpenServer 6.0.0 install?
Solution
If your system contains multiple disks, you may experience a problem where a USB floppy drive is unable to read an HBA floppy diskette during installation. You might also encounter this problem on a system with a single hard drive if you have multiple USB floppy drives installed.
The simplest way to avoid this problem is to run the installation with only the primary hard drive and one USB floppy drive hooked up.
If you are unable to disable your extra hard drives, run the SCO OpenServer installation and do the following:
1. At the ``Load more HBA drivers'' prompt, insert the
HBA diskette then press <Alt><SysReq>h to switch to the
console text screen to see the enumeration of the USB
floppy device. You should see:VT0>0:0,7,0: HBA : (usb_msto,1) USB USB HBA
0,0,0: DISK : MITSUMI USB FDD 10392. To determine the p0 device node that is used to access the USB floppy drive (for example, c0b0t0d0p0 or c1b0t0d0p0), run the following commands:
VT0> cd /dev/dsk
VT0> l *p0You should see:brw-rw-rw 1 root sys 7679,184 Jun 9 13:07 c0b0t0d0p03. Verify that this is the correct node for the USB floppy drive by briefly opening the device and noting that the light on the floppy drive flashes and that no error message is displayed:
VT0> < c0b0t0d0p04. Rename the USB floppy drive node as a c3 node:
VT0> mv c0b0t0d0p0 c3b0t0d0p05. Press <Alt><SysReq><F1> to switch back to the installation.
6. Select Yes at the ``Load more HBA drivers'' prompt
to load the HBA driver(s) from the HBA floppy diskette
then continue with the rest of the installation.