Technical article 127169

How do I add a SCSI controller to my already installed OpenServer 6.0.0 system?

OpenServer 6.0.0

Written · Last revised

Problem

How do I add a SCSI controller to my already installed OpenServer 6.0.0 system?

I have tried to add a SCSI card but when I boot my server after installing the card, my kernel does not see the card or load the driver for the card.

Cause

The OpenServer 6.0.0 kernel only contains SCSI HBA drivers
for those cards that are detected at installation time
(ISL).

A SCSI card that is plugged into your server after ISL will not be detected by the kernel because the kernel does not have a BHA driver loaded for your SCSI card.

Solution

You will need to install the correct SCSI HBA driver onto your OpenServer 6 server before you can begin to configure and use the card and the devices attached to it.

Updated drivers for OpenServer 6.0.0 are also posted at:

http://www.sco.com/support/update/download/product.php?pfid=12&prid=20

Please see the updated driver README for details on how to install these HBAs onto your system.

If you dont find the driver you are looking for at the above URL then the OpenServer 6.0.0 CD media contains a number of SCSI HBA drivers in pkgadd(ADM) format. For a list of the drivers please see:

http://osr600doc.xinuos.com/en/GetStart/gsgC.HWconfig.html#gsgC.HWconfig.HBAsupp

To install one of more of these drivers, place the OpenServer 6.0.0 CD1 into the cdrom drive and, as root, run:

# pkgadd -d /dev/cd0

You will be presented with a list of HBAs that you can install.

Alternatively you can install a specific driver (e.g. the Adaptec Ultra160 Family PCI SCSI IHV HBA driver) using:

# pkgadd -d /dev/cd0 adst70

Please note the pkgadd(ADM) command will only install the HBA driver. It will not dynamically load it into the running kernel.

You can do this using the modadmin(ADM) command as follows:

# modadmin -l adst70

Please note that OpenServer 6.0.0 autodetects and autoloads HBA drivers at boot time.

On each subsequent reboot your will NOT therefore have to manually load the driver as described above.

From the Xinuos technical article database, record 127169. Reproduced with permission. The original is at www.sco.com/ta/127169, which is reachable but blocked from search engines.

Next step

Need this fixed rather than explained?

Tell us the release, what the system runs and what it is doing. We will reply by email with what we would do next.

  • You deal with the people who do the work
  • No obligation, and no upgrade required before we will help
  • We tell you plainly if something is not worth doing

Send an enquiry

We reply by email. If a server is down, say so in the first line. You can also write to help@scoexpert.com.