Problem
I have had to restore my server using the Emergency Recovery Disks and Emergency Recovery Tape onto a fresh disk.
However, when the server boots I get the error message "No OS found" or equivalent, or the cursor just blinks and does not proceed further.
Cause
The emergency recovery restore will restore data to a fresh disk but will not write the Master Boot Record onto the disk.
This is because there may be a boot loader there already in the Master Boot Record, for example, "grub" or System Commander, if there are multiple operating systems on the disk.
Solution
This problem has been reported to SCO Engineering.
A workaround is to use the following steps:
a) Boot from the Emergency Recovery Floppies
b) Mount the filesystems from the Emergency Recovery menu
c) Enter the command: # chroot /mnt /bin/sh d) Enter the command: # fdiskand select option 0 (overwrite system master boot code) to ensure that the Master Boot Record is written again.
e) "exit" the "chroot" and the "exit" the shell.
f) Unmount the filesystems from the Emergency Recovery menu
g) Re-boot the server.NOTE: It has also been feature requested that a prompt is presented
for creation of the Emergency Disks during the initial installation of
the operating system. See also
emergency_disk(1M)
emergency_rec(1M) TA109633, "UnixWare 7 emergency disks."TA116163, "How do I install UnixWare7 on a Compaq ML Series server?"
TA116882, "How can I improve the restore performance during an emergency recovery procedure?"