Technical article 126577

My system fails to boot after installation/removal of a PCI mezzanine or riser device

OpenServer 6.0.0UnixWare 7.1.3UnixWare 7.1.4

Written · Last revised

Problem

I added a PCI "mezzanine" or "riser" expansion device to my working system and now the system panics with the message:

"vfs_mountroot: cannot mount root"

Cause

Some recent computer systems in small form factor rack mountable configurations make use of a special PCI expansion device called a PCI "mezzanine" or "riser". The PCI mezzanine attaches to the system mainboard like a small mid-plane, adding one or two PCI expansion slots at a right-angle such that the slots are horizontal, making them parallel to the mainboard. This physical configuration of stacking PCI expansion cards in "pancake-like" fashion allows normal full-sized PCI expansion cards to be installed in 1U and 2U form factor chassis.

Mezzanine cards that offer a single PCI expansion slot are usually just right-angle PCI adaptors that have no impact on the system hardware configuration. However, mezzanine cards that offer multiple PCI slots may contain PCI-to-PCI bridge hardware that can potentially change the underlying PCI bus topology of the hardware when the PCI mezzanine is added or removed.

If there is a change in the underlying bus enumeration that affects the bus number of the PCI bus in which the root disk host bus adaptor (HBA) is installed, the operating system will fail to boot. When this occurs the operating system will halt with: "vfs_mountroot: cannot mount root".

Solution

SCO is actively working with hardware vendors affected by this article to resolve the issue. In the interim, customers who want to use PCI mezzanine devices with embedded PCI-to-PCI bridge hardware should install the operating system with the device present. The PCI mezzanine should not be added or removed once the operating system has been installed.

If a user adds/removes a PCI mezzanine or riser
expansion device after initial system installation
and subsequently observes a panic on reboot with
the message "vfs_mountroot: cannot mount root", the
card configuration in the system should be restored
to its prior state and the system will reboot
normally.  In this situation, adding or removing a
PCI mezzanine expansion card would require a fresh
installation of the operating system.

From the Xinuos technical article database, record 126577. Reproduced with permission. The original is at www.sco.com/ta/126577, which is reachable but blocked from search engines.

Next step

Need this fixed rather than explained?

Tell us the release, what the system runs and what it is doing. We will reply by email with what we would do next.

  • You deal with the people who do the work
  • No obligation, and no upgrade required before we will help
  • We tell you plainly if something is not worth doing

Send an enquiry

We reply by email. If a server is down, say so in the first line. You can also write to help@scoexpert.com.