Technical article 127053

My system panics at first install screen during an attempted install of SCO OpenServer 6.0.0, 5.0.7 or UnixWare 7.1.4

OpenServer 6.0.0OpenServer 5.0.7UnixWare 7.1.4

Written · Last revised

Problem

I am trying to install my SCO Operating System but the install stops at the first install screen (Restricted Rights) and displays a panic message.

The panic message on an OpenServer 6 system will be similar to:

PANIC: kernel-mode address fault on user address 0x3 Kernel Page Fault from (cs:eip) = (100:F048D4FA): eax=0 ebx=F973EC00 ecx=1 edx=0 esi=F07DB788 edi=F973EC29 ebp=F973EC18 esp=FFFDA830

DEBUGGER:
eax:   0 ebx:F973EC00 ecx:   1 edx:   0 efl:   10296
esi:F07DB788 edi:F973EC29  esp: FFFDA828 ebp:F973EC18
regset:0
usbd_attach_desc_parse+19A: movzbl 0x03(%eax),%eax
HARDWARE: This problem may occur on uncertified systems. One such
          system this issue has been reported with is the ASUS
          F8Series (F8SN) Laptop.

Cause

The panic is caused by incompatibilities between the USB implementation on the system you are installing on and the SCO Operating System.

These incompatibilities are addressed in:

Maintenance Pack 5 or later for OpenServer 5.0.7 Maintenance Pack 3 or later for OpenServer 6.0.0 Maintenance Pack 4 or later for UnixWare 7.1.4

Solution

You will need to:

- disable the USB subsystem in the BIOS of your machine - install your SCO Operating System - install the relevant Maintenance Pack - re-enable the USB subsystem in your systems BIOS

to workaround this problem.
For example:

On the ASUS F8Series (F8SN) BIOS has a "Security -> I/O Subsystem Security Menu" that allows to "LOCK" the USB components. (disable all USB devices). You need to set this to "LOCK" (Default is UNLOCKED).

OpenServer 5.0.7 also has the ability to disable the usb drivers at boot time during the installation process. If your system does not have the ability to disable the USB Subsystem in the BIOS then, specifically on OpenServer 5.0.7, you can at the Boot: prompt enter:

defbootstr disable=usb_uhci,usb_ohic,usb_ehci

to disable the usb drivers in the installation kernel.

Once installed, you will need to install Maintenance Pack 5 and then
reboot your system and enable USB again.

From the Xinuos technical article database, record 127053. Reproduced with permission. The original is at www.sco.com/ta/127053, which is reachable but blocked from search engines.

Next step

Need this fixed rather than explained?

Tell us the release, what the system runs and what it is doing. We will reply by email with what we would do next.

  • You deal with the people who do the work
  • No obligation, and no upgrade required before we will help
  • We tell you plainly if something is not worth doing

Send an enquiry

We reply by email. If a server is down, say so in the first line. You can also write to help@scoexpert.com.