Problem
The HP StorageWorks Hot-Plug 20/40-GB DAT drive and other
Hot-Plug models are available as an option on a number of
HP Proliant server systems. The hot-plug tape drive is
usually fitted to the hot-plug storage bay (which normally
accommodates hard drives), which is in turn usually
connected to an internal RAID controller. Is this
supported with OpenServer 5 & UnixWare 7 ? Solution
The HP StorageWorks Internal 20/40-GB DAT drive is supported with both OpenServer 5.x and UnixWare 7.x but is not supported as part of a hot-plug configuration (ie. the hot-plug feature is not supported).
This support status is confirmed within the product's quickspecs on HP's web-site:
http://h18000.www1.hp.com/products/quickspecs/10426_div/10426_div.HTML With HP/Compaq Extended Feature Supplements (EFS) 5.60 for Openserver 5 and 7.60 for Unixware 7, support was added for some tape drives on RAID controllers using the "ciss" driver. Consequently, the following models should work if plugged into the drive bays for the ciss RAID controller, as long as you do not attempt to use the hot-plug functionality:
-HP StorageWorks DAT 20/40 GB -HP StorageWorks AIT 35/70 GB -HP StorageWorks AIT 50/100 GB -HP StorageWorks DLT 20/40 GB
NOTES: The tape drives listed above are correct at the time of this writing.
However, this list is subject to change and customers should contact
HP/Compaq for the current supported models.In general, SCO Support do not recommend connecting a tape
drive unit to a RAID controller. We would instead advise
using a non-RAID SCSI controller (either embedded or
add-on) to host the tape drive.