Technical article 127124

Unable to set the onboard Intel ICH9R SATA RAID in native AHCI mode on HP Proliant ML310-G5

OpenServer 6.0.0OpenServer 5.0.7UnixWare 7.1.4

Written · Last revised

Problem

I have a HP Proliant ML310-G5 with a single SATA HD.

I would like to run this SATA controller in AHCI mode in order to install SCO OpenServer6 or UnixWare 7.1.4 using the "ahci" HBA in stead of "ide".

But entering the BIOS, I am not able to find anywhere how to set that up. In the previous models ML310-G4 or other similar spec of HP ML's, there was an option to do that.

I don't want to use the "ide" driver, but the "ahci", since "ahci" is much faster the "ide".

HARDWARE:  HP Proliant ML310-G5

Solution

HP has removed the AHCI enable/disable option from the HP Proliant ML310-G5 BIOS, therefore, you are only able to run the onboard Intel ICH9R in either SATA-Raid or Legacy IDE mode.

If you are installing SCO OpenServer 6.0.0 or Unixware 7.1.4, then your only option is to use the IDE mode ("ide" HBA), as there is no driver support for any type of Intel SATA Raid.

This also applies to SCO OpenServer 5.0.7 ("wd" ver. 3.0 BTLD)

From the Xinuos technical article database, record 127124. Reproduced with permission. The original is at www.sco.com/ta/127124, which is reachable but blocked from search engines.

Next step

Need this fixed rather than explained?

Tell us the release, what the system runs and what it is doing. We will reply by email with what we would do next.

  • You deal with the people who do the work
  • No obligation, and no upgrade required before we will help
  • We tell you plainly if something is not worth doing

Send an enquiry

We reply by email. If a server is down, say so in the first line. You can also write to help@scoexpert.com.