Technical article 127023

USB floppy not found when using `pkgadd -d diskette1`

OpenServer 6.0.0

Written · Last revised

Problem

I'm following another article which suggests installing from floppy using the command:

# pkgadd -d diskette1

This does not work with my USB floppy drive.

HARDWARE: USB floppy

Cause

USB floppy disks are treated as hard drives instead of floppies.

Solution

You can mount the USB floppy disk and install the package from the mount point.

Use `/sbin/sdiconfig -l` to locate the device id of the
floppy. Amongst the devices you should see the USB
controller and the floppy disk:
...
3:0,7,0: HBA     : (usb_msto,1) USB     USB HBA
  0,0,0: DISK    : TEAC    FD-05PUB        2000
...

In this case the USB controller is the 3rd controller on the system, so the floppy could be mounted using:

# mount /dev/dsk/c3b0t0d0p0 /mnt

Once mounted, you can use this pkgadd command to install the package:

# pkgadd -d /mnt

After the installation is complete, un-mount the floppy before removing it:

# umount /mnt
NOTE:     If you have trouble getting the floppy disk recognized try adding it
          to the subsystem again using the command `sdiadd -n`.

From the Xinuos technical article database, record 127023. Reproduced with permission. The original is at www.sco.com/ta/127023, which is reachable but blocked from search engines.

Next step

Need this fixed rather than explained?

Tell us the release, what the system runs and what it is doing. We will reply by email with what we would do next.

  • You deal with the people who do the work
  • No obligation, and no upgrade required before we will help
  • We tell you plainly if something is not worth doing

Send an enquiry

We reply by email. If a server is down, say so in the first line. You can also write to help@scoexpert.com.