Technical article 127041

WARNING: Your boot disk parameters were not detected by the bootstrap

OpenServer 6.0.0UnixWare 7.1.4

Written · Last revised

Problem

I am installing on a system with a SCSI Host Bus Adapter (HBA) as the primary disk controller on the system. The system seems to install fine but when I reboot I see a BIOS error indicating that BIOS cannot find a disk to boot from. A typical error may be similar to:

DISK BOOT FAILURE, INSERT SYSTEM DISK AND PRESS ENTER

During the installation, if I switch from the installation screen to the system console using

<Alt><SysRq> h
I see the error:

WARNING: Your boot disk parameters were not detected by the bootstrap.

At this time, a default geometry will be used.

Cause

The WARNING message usually occurs when the SCSI HBA on your server is not correctly configured.

Solution

Check your SCSI HBA configuration ensuring that the HBA is properly configured to act as a primary controller on your system.

From the Xinuos technical article database, record 127041. Reproduced with permission. The original is at www.sco.com/ta/127041, which is reachable but blocked from search engines.

Next step

Need this fixed rather than explained?

Tell us the release, what the system runs and what it is doing. We will reply by email with what we would do next.

  • You deal with the people who do the work
  • No obligation, and no upgrade required before we will help
  • We tell you plainly if something is not worth doing

Send an enquiry

We reply by email. If a server is down, say so in the first line. You can also write to help@scoexpert.com.