Problem
I have noticed that on the HP DL 380-G4 SCSI Server,only IRQ 5 & 7 are free in the BIOS to be allocated to a PCI device. I need to free other IRQs.
What BIOS settings need to be changed in order to free
more IRQs and to ensure no problems will occur when installing and
running SCO OpenServer 5.0.7, Openserver 6.0.0 or UnixWare
7.1.3 /7.1.4 ?HARDWARE: HP Proliant DL380-G4 SCSI Cause
The DL380-G4 SCSI has only two IRQ's free to play with. They are 5 & 7. All other IRQs are reserved in the BIOS. When entering the BIOS and in the PCI device configuration menu, you will notice that all the PCI devices are sharing IRQ 5.
IRQs 10 & 11 on the HP DL380-G4 SCSI are completely reserved by the BIOS and there is no way they can be freed to be used by other PCI devices.
Solution
In order to free some IRQ's for the used on-board PCI devices or additional PCI cards to avoid having too many shared IRQs and to ensure all SCO OpenServer 5.0.7, 6.0.0 and UnixWare 7.1.3 and 7.1.4 will install and run well on HP Proliant DL 380-G4, disable the following PCI devices in the BIOS if not used:
1- If you are not using the USB ports, then disable them.
2- If you are not using the COM1 or COM2 or both, then disable them. This will free IRQ 3 & IRQ 4
3-
If you are not using the HP iLo (Integrated Light Out), then
disable it.Once the above have been carried out in the BIOS, have the:
* HP Smart Array 6i (ciss) set to IRQ 5.
* The two Embedded NC7782 Dual Port PCI-X 10/100/1000T Gigabit network adapter (BroadCom) to share the IRQ 3 or 4 or one with IRQ 3 and the other with IRQ 4.
* you can use the IRQ 7 for additional PCI device, like SCSI controller for SCSI tape devices.
NOTES: Avoid setting IRQ 7 for the Embedded NC7782 network adapter,
this has been found to cause some issues with network speed. See also
TA126363 "Cannot install SCO OpenServer 5.0.7, using a BTLD on a floppy disk via USB floppy drive on a HP Proliant DL380-G4 that has no standard legacy floppy drive attached as default."